Configure the Kibana endpoint
editConfigure the Kibana endpoint
editHere’s a sample configuration:
apm-server.kibana.enabled: true apm-server.kibana.host: "http://localhost:5601"
Kibana endpoint configuration options
editYou can specify the following options in the apm-server.kibana
section of the
apm-server.yml
config file. These options are not required for a Fleet-managed APM Server.
apm-server.kibana.enabled
editDefaults to false
. Must be true
to use APM Agent configuration.
apm-server.kibana.host
editThe Kibana host that APM Server will communicate with. The default is
127.0.0.1:5601
. The value of host
can be a URL
or IP:PORT
. For example: http://192.15.3.2
, 192:15.3.2:5601
or http://192.15.3.2:6701/path
. If no
port is specified, 5601
is used.
When a node is defined as an IP:PORT
, the scheme and path are taken
from the apm-server.kibana.protocol and
apm-server.kibana.path config options.
IPv6 addresses must be defined using the following format:
https://[2001:db8::1]:5601
.
apm-server.kibana.protocol
editThe name of the protocol Kibana is reachable on. The options are: http
or
https
. The default is http
. However, if you specify a URL for host, the
value of protocol
is overridden by whatever scheme you specify in the URL.
Example config:
apm-server.kibana.host: "192.0.2.255:5601" apm-server.kibana.protocol: "http" apm-server.kibana.path: /kibana
apm-server.kibana.username
editThe basic authentication username for connecting to Kibana.
apm-server.kibana.password
editThe basic authentication password for connecting to Kibana.
apm-server.kibana.api_key
editAuthentication with an API key. Formatted as id:api_key
apm-server.kibana.path
editAn HTTP path prefix that is prepended to the HTTP API calls. This is useful for the cases where Kibana listens behind an HTTP reverse proxy that exports the API under a custom prefix.
apm-server.kibana.ssl.enabled
editEnables APM Server to use SSL settings when connecting to Kibana via HTTPS.
If you configure APM Server to connect over HTTPS, this setting defaults to
true
and APM Server uses the default SSL settings.
Example configuration:
apm-server.kibana.host: "https://192.0.2.255:5601" apm-server.kibana.ssl.enabled: true apm-server.kibana.ssl.certificate_authorities: ["/etc/pki/root/ca.pem"] apm-server.kibana.ssl.certificate: "/etc/pki/client/cert.pem" apm-server.kibana.ssl.key: "/etc/pki/client/cert.key"
For information on the additional SSL configuration options, see SSL/TLS output settings.