cat shards

The shards command is the detailed view of what nodes contain which shards. It will tell you if it’s a primary or replica, the number of docs, the bytes it takes on disk, and the node where it’s located.

Here we see a single index, with one primary shard and no replicas:

GET _cat/shards

This will return

twitter 0 p STARTED 3014 31.1mb 192.168.56.10 H5dfFeA

If you have many shards, you may wish to limit which indices show up in the output. You can always do this with grep, but you can save some bandwidth by supplying an index pattern to the end.

GET _cat/shards/twitt*

Which will return the following

twitter 0 p STARTED 3014 31.1mb 192.168.56.10 H5dfFeA

Let’s say you’ve checked your health and you see relocating shards. Where are they from and where are they going?

GET _cat/shards

A relocating shard will be shown as follows

twitter 0 p RELOCATING 3014 31.1mb 192.168.56.10 H5dfFeA -> -> 192.168.56.30 bGG90GE

Before a shard can be used, it goes through an INITIALIZING state. shards can show you which ones.

GET _cat/shards

You can get the initializing state in the response like this

twitter 0 p STARTED      3014 31.1mb 192.168.56.10 H5dfFeA
twitter 0 r INITIALIZING    0 14.3mb 192.168.56.30 bGG90GE

If a shard cannot be assigned, for example you’ve overallocated the number of replicas for the number of nodes in the cluster, the shard will remain UNASSIGNED with the reason code ALLOCATION_FAILED.

You can use the shards API to find out that reason.

GET _cat/shards?h=index,shard,prirep,state,unassigned.reason

The reason for an unassigned shard will be listed as the last field

twitter 0 p STARTED    3014 31.1mb 192.168.56.10 H5dfFeA
twitter 0 r STARTED    3014 31.1mb 192.168.56.30 bGG90GE
twitter 0 r STARTED    3014 31.1mb 192.168.56.20 I8hydUG
twitter 0 r UNASSIGNED ALLOCATION_FAILED

These are the possible reasons for a shard to be in a unassigned state: